- Product MPN
E178FP
- Key Features
Screen type: Active matrix - TFT LCD
Screen dimensions: 17 inches (17-inch diagonal viewable image size)
Preset display area: Horizontal 13.3 inches; Vertical 10.6 inches
Pixel pitch: 0.264 mm x 0.264 mm
Viewing angle: Viewing angle 160° (vertical) typ, 160° (horizontal) typ
Luminance output: 300 cd/m²(typ)
Contrast ratio: 800:1 (typ)
Faceplate coating: Antiglare with hard-coating 3H
Backlight: 4 CCFLs backlight
Response Time: 5 ms typical (Black to White)
- Resolution
Horizontal scan range: 30 kHz to 81 kHz (automatic)
Vertical scan range: 56 Hz to 76 Hz
Optimal preset resolution: 1280 x 1024 at 60 Hz
Highest preset resolution 1280 x 1024 at 75 Hz
- Preset Display Modes
Display Modes: Horizontal Frequency (kHz) / Vertical Frequency (Hz) / Pixel Clock (MHz) / Sync Polarity (Horizontal/Vertical)
VGA 720 x 400:
31.5 / 70.1 / 28.3 / -/+
VGA, 640 x 480:
31.5 / 60.0 / 25.2 / -/-
VESA, 640 x 480:
37.5 / 75.0 / 31.5 / -/-
VESA, 800 x 600:
37.9 / 60.3 / 40.0 / +/+
VESA, 800 x 600:
46.9 / 75.0 / 49.5 / +/+
VESA, 1024 x 768:
48.4 / 60.0 / 65.0 / -/-
VESA, 1024 x 768:
60.0 / 75.0 / 78.8 / +/+
VESA, 1152 x 864:
67.5 / 75.0 / 108.0 / +/+
VESA, 1280 x 1024:
64.0 / 60.0 / 108.0 / +/+
VESA, 1280 x 1024:
80.0 / 75.0 / 135.0 / +/+
- Electrical
Video input signals: Analog RGB - 0.7 Volts +/-5%, 75 ohm input impedance
Synchronization input signals: Separate horizontal and vertical synchronizations, 3.3V Cmos or 5V TTL level, positive or negative sync
Power AC input voltage / frequency / current: 100 to 240 VAC / 50 or 60 Hz / 1.5A (RMS) Max.
Inrush Current: 110V - 30A (Max.); 220V - 60A (Max.)
Signal cable type: D-sub: Detachable, Analog, 15pin, blue connector, attached to the monitor
- Physical Characteristics
Dimensions (with stand): Height 14.98 inches; Width 14.75 inches; Depth 5.51 inches;
Weight: Monitor (Stand and Head) 10.2 lb; Monitor Flat panel only (VESA Mode) 8.1 lb
- Environmental
Temperature: Operating 5° to 35°C (41° to 95°F); Nonoperating -20° to 60°C(-4° to 140°F)
Humidity: Operating 10% to 80% (noncondensing); Nonoperating 5% to 90% (noncondensing)
Altitude: Operating 3,657.6 m (12,000 ft) max; Nonoperating 12,192 m (40,000 ft) max
- Power Management Modes
If you have VESA's DPMS compliance display card or software installed in your PC, the monitor automatically reduces its power consumption when not in use. This is referred to as Power Save Mode. If input from keyboard, mouse or other input devices is detected by the computer, the monitor automatically resumes functioning. The following information shows the power consumption and signaling of this automatic power saving feature.
VESA Mode: (Video / H-sync / V-sync / Power Used / Power Saving / LED color)
ON:
Active / Yes / Yes / maximum 40W, typical 34W / 0% / Green
Power Saving:
Blanked / No / Yes / <=2W / >80% / Amber
Blanked / Yes / No / <=2W / >80% / Amber
Blanked / No / No / <=2W / >80% / Amber
Switch Off*:
Blanked / -- / -- / <=1W / >80% / Off
- Plug and Play Capability
You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. Most monitor installations are automatic; you can select different settings, if required.
Order Computer Monitor 
